This is the Gold Cube Concentrator 4 stack deluxe with the Gold Cube Stainless Steel Topper Combo - SAVE MONEY and buy them together!!!!
The GOLD CUBE CONCENTRATOR - THE HOTTEST PIECE OF PROSPECTING EQUIPMENT ON THE MARKET
The "Gold Cube" works amazingly well. Gold Fever Prospecting has tested it thoroughly and we use it in the shop daily as our primary concentrating tool - we love it and so will you. IT'S CRAZY FAST AND EXTREMELY EFFICIENT - IT WON'T LOSE GOLD. Come see it in action at our Southern California showroom or watch the videos below.
Hold on partner...put away that tablespoon and grab the big scoop! The Gold Cube concentrator is ready to turn tons of your raw gold bearing material into just ounces of super rich concentrates in minutes...not days.
The Gold Cube is small and light enough to fit into the trunk of your car. With a battery (not included) and a small 12 volt pump you're ready to take it on the beach, the creeks, tailings piles, or just use it to clean up your concentrates at home.
The Gold Cube is a patent-pending, well proven product backed by countless hours of research & development!
The Gold Cube consists of stacking trays made of LDPE (low density polyethylene) indestructable plastic as thick as a cutting board and with about the same footprint!
A basic Gold Cube consists of 1 slick plate, and two concentrator trays, but you can add as many trays as you like, depending on your specific needs (like extra fine gold recovery) and location, it's totally up to you! (We use a 4 stack to save even the finest gold).
VIDEO: Prototype test of Gold Cube processing 1,000 Lbs. down to 1 Lb. of super concentrates. We classified the materials with a #8 screen then pushed the limits of the Gold Cube using only three units instead of the usual 4
GOLD CUBE Vortex Matting
Each square inch of Vortex Matting contains 49 individual low pressure zones that work similar to a tornado. That's over 7,000 per individual matt! As the gold gets lodged into the tornado, the low pressure drives it too the bottom, forcing black sand and other heavies out of the way. Yes gold is a bully and stuborn. The only way it's going to leave the vortex is when you clean it out. This is why we can run thousands of pounds thru a Gold Cube and still only get a few ounces of Black sand and of course gold. A 3 stack cube unit has over 21,000 a 4 stack cube has over 28,000! Gold doesn't stand a chance of getting out.
So... do you want to bring home the whole creek, or just the gold?
* Fiddle-free water control and slick plate.
Slick Plate. The slick plate on the Gold Cube has a precisely controlled water flow that is designed to process very large amounts of 8 mesh and smaller material in a very short time. Withcontrolled water flow, the slick plate does 2 things: 1. It turns aggregate material into a slurry, and 2. The water flow forces the lighter particles ahead of the heavier material. It is quite exciting to actually see your fine gold creeping down the slick plate! Gold, the heaviest element in the slurry, will be the last to reach the trough.
* Unique G-Force technology cleans and seperates the gold.
G-Force Separator. The slurry then falls into a gated trough and will be forced under water. Then centrifugal force will force the gold to the outer edge of the rounded trough. The slurry will then exit the trough on the opposite side of the gate. After exiting the gated trough, the slurry is forced to stand up and form a column. The purpose of this column is to actively stack the particles by specific gravity. Lighter, faster moving particles race past the heavier particles and exit the column first. The Gold Cube's forced gravitational, centrifugal and columning effect is called "the G-Force."
* Vortex matting traps gold and self cleans for hours of use.
Vortex Matting. The Gold Cube's vortex matting works because water flow interacts with a combination of very small pillar walls and cavities—about 7,056 of them per mat. Just like a tornado, the spinning creates a low pressure zone in the center of each of the cavities. Passing gold will be trapped and forced to the bottom of the vortexes and held in place by the lighter material. As gold-laden material is introduced into each vortex mat, it will displace and replace the lighter material. This will create about a cup of super concentrates at clean-up. Amazing!
4 Stack Deluxe (includes stand, pump ) SMRP $479.95
Deluxe units include the following:
• One Slick Plate
• Two or three Separator Trays (depends on model)
• Pump - 1100 gph bilge pump
• Hose Adapters
Stand Specs: (stand is also available separately and is already included in deluxe units)
• 18" Square Assembly
• Adjustable to 16"
• Zinc Plated
Gold Cube Dimensions for the single tray are 16x16x8" and the weight is 7.2 pounds.
The 4 stack deluxe is 16x16x22 and weighs 33 pounds. This is item weight, not ship weight.
The Gold Cube Topper
The cube is now Shovel Ready!
Take the hassle out of classifying and increase your yield at the same time! 3/16th punch plate allows for a 50% size increase, double the slick plate for increased separation and nugget traps instantly show the gold. Simply attach the stand extensions to your existing cube stand and attach the 5 foot hose (included) and you are ready to go for the gold!
The Topper can be used as a high banker/beach box configuration using the standard 1100 gph pump or a 2000 gph pump is available with 12 foot hose. The topper works very well as a recirculation unit or can function as a stand alone classifier.
The Topper is constructed of thick ABS material with built in adjustable spray bar. The punch plate is stainless steel that simply slides into the unit. Stainless is the best choice for salt water use, however, the anodized just needs a good clean with fresh water.
Items Included in Shipping are:
• Topper Unit
• Stand Extensions
• 5 Ft. Flexible Poly Hose