2-piece Carbon Fiber (glossy finish) Shaft for the new Minelab Equinox. This listing is just for the Upper & Middle Shafts, you still have to use your stock Equinox coil rod, arm cuff and of course the Control Head/Handle. Two of my Plugger Shaft Locks are included and there is absolutely no wobble.
Shaft is drilled for the stock arm cuff (3-holes spaced 1" apart starting 1-7/8" from the end. There are also 3 positions (holes) for the handle, starting at 12.5" from the end of the upper shaft and spaced 1.5" apart (12.5", 14" & 15.5") There are 7 holes in the middle shaft for adjusting the stock coil rod spaced at 1-1/2" apart starting about 2" from lower end. Both shafts together weigh less than 6 ounces (actually 5.7oz). Assembled length is just over 36".
For packing purposes, both shafts are less than 21" long, however, it is also important to note that the stock coil rod is 24" long.
Detector, Custom Armcuff & Coil are not included, shown for illustration only!
Your Stock Arm cuff will fit perfectly on this shaft.